POTAIN

Potain Igo T 99

An electrically powered self-erecting tower crane for residential, commercial and prefabricated construction on space-constrained sites.

Equipment inquiry

Discuss the required working method, configuration, delivery location, and project timeline with Vernep.

Request equipment
Potain Igo T 99 telescopic self-erecting tower crane
Potain Igo T 99
At a glance

Key specifications

Maximum load
6 t
Available only within the applicable charted inner radius
Maximum working radius
48 m
Horizontal full-jib configuration
Tip capacity at 48 m
1.2 t
Full 48 m horizontal-jib chart
Maximum horizontal hook height
38.5 m
Requires the applicable additional mast sections
Maximum raised-jib hook height
56.5 m
30-degree raised-jib configuration
Working footprint
4.5 × 4.5 m
Excludes access and erection clearance
Equipment profile

Built around the project configuration

The Potain Igo T 99 is an electrically powered self-erecting tower crane for residential, commercial and prefabricated construction on space-constrained sites. Its telescopic mast and configurable jib provide up to 48 m working radius, while a compact support base and remote-controlled erection reduce the area needed to establish the crane.

Five principal horizontal jib lengths and a folded-jib working position allow the load curve to be matched to the site. With additional mast sections, horizontal-jib hook height reaches 38.5 m; raising the jib to 30 degrees extends the maximum hook height to 56.5 m.
Technical data

Detailed specifications

Performance data grouped for quick review and comparison.

Jib and lifting configurations

Maximum load 6 t within the applicable charted inner radius
Horizontal jib lengths 31.7, 33.8, 40, 45 and 48 m
Folded-jib working position 32 m
Tip capacity with 48 m jib 1.2 t
Tip capacity with 45 m jib 1.5 t
Tip capacity with 40 m jib 1.95 t
Tip capacity with 33.8 m jib 2.7 t
Tip capacity with 31.7 m jib 3.0 t

Mast and working geometry

Horizontal-jib hook-height range 20.5–38.5 m
Maximum raised-jib hook height 56.5 m at 30 degrees
Additional mast sections Up to three 6 m sections
Working footprint 4.5 × 4.5 m
Rear slewing radius 3.0 or 3.3 m, configuration dependent
Erection arrangement Top-deploying jib with hydraulic self-erection

Mechanisms and controls

Hoist system 25 HPL with permanent four-fall reeving
Maximum published hoist speed Approximately 54 m/min
Maximum published trolley speed Approximately 70 m/min
Maximum slewing speed Approximately 0.8 rpm
Erection assistance Potain Smart Set-Up remote-guided sequence
Remote-control profiles Three programmable operating profiles
Optional zoning and anticollision Top Tracing 3

Power, ballast and transport

Site supply options 400 V / 50 Hz or 480 V / 60 Hz
Power Control operating range Approximately 21–34 kVA
Approximate erection power 15 kVA
Empty weight Approximately 20,995 kg without ballast or transport axles
Documented ballast Approximately 46,200 kg
Folded transport length Approximately 15.65 m
Transport width Approximately 2.5 m
Maximum documented transport height Approximately 4.0 m
Transport-weight range Approximately 22,985–24,025 kg, axle-package dependent
Equipment inquiry

Match the machine to your project.

Send Vernep the required drilling method, pile diameter, target depth, ground conditions, available working height, delivery location, and project timing. We will use those details to review a suitable configuration or available unit.

Request equipment support